offlinevictoria.blogg.se

1. Microsoft office 2008 for mac [old version] unbox how to#
2. Microsoft office 2008 for mac [old version] unbox pro#
3. Microsoft office 2008 for mac [old version] unbox password#

My last known good never worked either, but I've also never been able to get it to boot to safe-mode. I''m hoping that since I can access the drive in question from a bare-bones machine, I can just rename/remove and insert whatever file I need to and then put the drive back into the original machine. Long ago and far away was the install, and I have tried all the usual suspects as far as PW's are concerned.

Microsoft office 2008 for mac [old version] unbox pro#

Upgraded to XP pro from win 2Kpro, so I have the origional MS XP PRO disk. I'm not sure what you mean by "System configuration", do you mean the hardware that's being used? I state again, that the method of replacing the gdi32.dll file ruined my PC and the only way I could fix it was to put the previous file back in the system32 directory in DOS. After about 10 tries, it just suddenly finally loads! Sometimes it will boot into safe mode, sometimes it won't. That black XP logo screen never loads, it's like if it were an animation, only the very first frame of the "animation" loads where the first frame is dark and low contrast so-to-speak. Regardless of what is chosen there, nothing works. All appears to be normal, and the very instant the black XP logo screen starts to "fade in", it stops and reboots, then stops at that menu where it says "Windows didn't load on previous attempt" and it gives you those options like safe mode, safe mode with networking, last known good configuration, etc. So there are no minidump files or Event Viewer entries. Please share any/all of this information at shashankbansalmicrosoftcom

System event viewer logs (from safe mode) and/or contents of %windir%\minidump. Can you try to boot with automatic restart disabled (press F8 before the OS selection screen) and share the result? Any messages displayed on the screen etc.Ĥ.

Microsoft office 2008 for mac [old version] unbox password#

(Partimage Is Not Ghost), which is an imaging program similar to Ghost, one of the options it comes with is an option to blank the local admin password on a machine, though I have not used this myself other than for imaging PC's.įor everyone facing the endless reboot issue, we would need to have some more information.ģ. Was your PC set up with factory installation disks or pre-built from the factory? It may be that there is no admin password if that is the case, and if that is not the case, have a look for P.I.N.G.

Microsoft office 2008 for mac [old version] unbox how to#

I did find this article about how to un-install SP3 from Recovery Console (so far, I have not been able to get into RC - none of the passwords have worked - but I'll keep trying), but not sure if I should attempt this or wait to see if a MSFT tech has any ideas. (safe mode, command prompt, boot normally, etc.) None of the options will work from there, however. I think others are getting an error message, we don't seem to be getting an error message, it just keeps coming up the 'failed to start on last attempt' screen. I have already replaced the GDI32.dll by removing the drive and installing it as a slave and manually replaced the GDI32.dll from a barebones machine that is running SP3. This issue is not responding to the GDI32.dll fix that has worked on older SP3 versions.